Z axis goes off end of the bed

//Z axis goes off end of the bed
Z axis goes off end of the bed2018-12-07T16:54:19+00:00

General Discussion Z axis goes off end of the bed

  • Creator
    Topic
  • #69751
    M

    Mikeyjp
    Participant
    Post count: 2

    Hello

    I had this printer 2nd hand, so am a bit of noob with how it was set up to start with. I recently got the extender, so had to take it all apart, after a couple of teething problems, that Tiertime, helped with with i have one last problem 😛 how do i sort this out?

    When doing the calibration, the nozzle is out of sync with where it thinks the bed is

    [img]https://i.imgur.com/HMVqbeu.jpg[/img]

    Thanks

Viewing 2 replies - 1 through 2 (of 2 total)
  • Author
    Replies
  • M
    Mikeyjp
    Participant
      Post count: 2

      <p>Hi</p><p> </p><p>I can not move it anymore left as the screwheads that hold it the the thing that goes up and down (technical term lol) are in the way, so it will not go any further over to the left</p>

      j
      Jason Wu
      Keymaster
        Post count: 12

        Hello,

         

        you may need to adjust the position of the horizontal arm, loosen the 3 screws on the bracket of the Y axis, move the Y axis( arm) to left side (side with motor) and try again.

      Viewing 2 replies - 1 through 2 (of 2 total)

      You must be logged in to reply to this topic.