z axis level bed problems

//z axis level bed problems
z axis level bed problems2018-11-29T22:03:44+00:00

Help Section z axis level bed problems

Tagged: 

  • Creator
    Topic
  • #69453
    b

    baykush
    Participant
    Post count: 4

    <p>Hi</p><p>I am having problems with my prints. <br />Regardless of the print orders I gave, the first layer starts 5 mm above the ground. I calibrate bed, it seems fine but when I start a print order the problem still occurs.</p><p>bets regards</p><p>Serdar</p>

Viewing 1 replies (of 1 total)
  • Author
    Replies
  • k
    kirkdis33
    Participant
      Post count: 21

      <p>Hi Baykush,</p><p>first of all please tell us what kind of cetus you have. the small or the big one. Then it would be helpful if you provide fotos, or a video (youtube) here. also the value you put in the cetus application for Z-Axis is quite important.</p><p>If I remember mine is around 180mm +- the distance to the 9points on the plate.</p><p>In case you did everything right it could be an issue with the z-Axis motor, or the belt. As the cetus is only using the motorsteps (or revolutions of the stepper motors) for measuring the distance it seems that there is a problem. Sorry but out of your one sentence it´s hard to solve your issues or help with advice.</p><p>best</p><p>kirkdis</p><p> </p>

    Viewing 1 replies (of 1 total)

    You must be logged in to reply to this topic.